Skip to content

Heat Pump Hot Water Belmont

Heat pump hot water in Belmont is a changeover we supply, size, install and commission when an old electric or gas tank gives out. From the plumber in Belmont we quote the full figure up front, and a loan tank keeps the showers running while the new unit arrives.

Licensed plumbers and gas fitters · NSW Lic. 359278C

Last updated September 2026

Storage hot water unit fitted against a house wall
Newly installed storage hot water unit

Why Upgrade to a Heat Pump?

An electric element heats water by burning power flat out. A heat pump runs a refrigeration cycle instead, and that difference shows up on every bill.

  • The unit pulls warmth from the ambient air and transfers it to the tank, so the daily running draw sits well below what an element or a gas burner uses.
  • It mounts outdoors on a slab or bracket, which frees up the corner the old tank occupied inside or under the house.
  • The changeover takes the old cylinder away, so nothing sits on the nature strip for a week.

For a tank that might still have life in it, the repair-or-replace call is covered under hot water repairs before you commit to a swap.

Electric storage hot water unit after installation

How We Install a Heat Pump

The changeover runs in four steps, and the figure holds from first quote to final invoice:

  1. 1

    Ring or send the form

    Call (02) 4063 3475 or use the form to explain the fault. We ask enough to bring the right equipment the first time.

  2. 2

    A fixed price first

    A plumber inspects the job and names a fixed figure up front. Nothing gets started until you give the go-ahead.

  3. 3

    Out with the old tank

    We lift out the old cylinder, mount the heat pump on its slab or bracket, run the connections and commission the unit before we leave.

  4. 4

    Covered for a year

    Every job carries our 365-day warranty on all work. If something we did isn't right, ring the same number.

What Moves the Price?

Unit size drives most of a heat pump price, and the site does the rest:

  • The unit size, matched to bathrooms, bedrooms and how many people live there
  • Whether the existing water pipes and isolation valves can be reused or need swapping
  • Where the outdoor unit sits, since a ground slab costs less than a bracket on a fibro wall
  • Taking the old tank away, plus any connection upgrades the day turns up

We provide up-front, honest quotes that will always match the final price, should you decide to go ahead.

Where the Peninsula Suits a Heat Pump

Post-war tanks meeting their end

The fibro and weatherboard cottages built through the 1940s to 1960s carry a large share of the suburb's hot water units, and plenty of those tanks are running on borrowed time. A heat pump is the natural swap for that stock: same water connections, lighter load on wiring that has been in the walls since the build.

Plenty of households have already switched

Area-level install records count 1,369 heat pump units in the locality, alongside 1,369 solar hot water systems. From the cottages behind the TAFE NSW Belmont campus to the newer townhouses closer to the lake, the changeover suits both ends of the housing.

What Customers Say

[The plumber] & his young helper were courteous, well mannered & competent when replacing the solar hot water station pump at my property
Jennifer

When We're Not the Right Call

Wiring first

If the switchboard needs attention before any new unit connects, that belongs to a licensed electrician, and we pass the job across rather than quote it as ours.

Staying on gas

Houses keeping gas storage or continuous flow are better served there, and the hot water page sets those alternatives out side by side. The gas appliance installation page covers what changes when an appliance gets swapped.

Heat Pump Hot Water Questions

Do you quote a fixed figure for a heat pump install in Belmont?

Yes. The whole figure is set out ahead of any booking, covering supply, the changeover, commissioning and removal of the old cylinder. What shifts it between houses is unit size, where the outdoor unit mounts and any valve or pipe work the connections turn up needing.

Will a heat pump cope with the salt air here?

The outdoor unit faces the same coastal exposure as every tap and pipe on the block, so siting does the protecting. We mount it sheltered from direct spray, raised off damp ground and with open airflow, and the exposure is built into where we put it at quoting stage.

Can my old electric tank be swapped without rewiring?

Mostly, yes. A heat pump draws far less power than an old element, so the existing circuit often carries it. We check that on site before quoting, and if the switchboard needs a licensed electrician first, the job goes across to one rather than into our quote.

Do you install heat pumps outside Belmont too?

Yes. The run takes in Belmont North, Redhead, Belmont South and Valentine, and every install on those streets gets the same fixed quote and warranty as a job in the town centre itself.

Need a plumber? Call or send the form

Call (02) 4063 3475 or send the form below. Available 24/7, you see a fixed figure ahead of any work, and every job carries our 365-day warranty on all work.

Call (02) 4063 3475

Request a callback

Leave a name and number and a plumber will ring you back.

We use your details only to call you back about this job. See our privacy policy.

Call (02) 4063 3475 Get a quote